You can download a PDF attachment of the Maintenance and Service Procedures below.
Prior to your first carve, please review the X-Carve Pro Safety Manual. Always use common sense when operating the X-Carve Pro, and never leave the machine unattended while running
Modifications to the X-Carve Pro or the use of any accessory or attachment that has not been recommended by the manufacturer and may result in risk of injury or damage to components. Please refer to the Limited Warranty documentation for additional information.
Here is a quick overview of the X-Carve Pro’s maintenance schedule:
Maintenance | Interval |
Power cycle - Shut down X-Carve Pro at the back of the controller when not in use. | Daily, after use |
Vacuuming and cleaning | Daily, as needed/per use |
Check spindle and collet/collet nut | Daily, as needed/per use |
Controller dust filter | Weekly, as needed/per use |
Check grease on linear rails and ballscrew with grease gun and Easel greasing project | Pre-greased at factory. Greasing can start at first month from purchase. Check every 2-6 months or whenever levels are low when checked. The rails should feel slightly greasy when touched. You should only use the Inventables-approved grease tube and grease gun: X-Carve Pro Grease. |
Replaning the wasteboard | Every few months, as needed to maintain flatness |
Check wasteboard screws are tightened (t-slot tracks and quadrants) | Every 6 months or if you notice slight offset in carves |